Farmall & IHC Tractors Discussion Board |
Re: 706 rebuild update
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by the tractor vet on February 01, 2005 at 13:45:58 from (4.124.83.240):
In Reply to: Re: 706 rebuild update posted by caseyc on February 01, 2005 at 10:54:18:
I have had problems with this before with felpro gskt. as they are jusnk with there wood fiber cores . Not as much with the victors but have had to go to the diesel toqure spec and copper coat . As far as the gas thing read the book and it tells you that they need 93 min. and on the timming thing there it depends wheather it is a 263 or a 291 as they set differant and on the 291's they are a bit fussy on this , Nothing more then 23 degrees total and if someone put the wrong dist. ya got problems . I have run them at 24-25 degrees with the curb timming at +5 for quicker cold start and it also take out some stumbel but ya got to back up the total in the dist. and to to do that ya have to recurve .
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|