Farmall & IHC Tractors Discussion Board |
Re: moved post--lee
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by lee on January 31, 2005 at 15:00:26 from (24.24.95.246):
In Reply to: Re: moved post--lee posted by CNKS on January 31, 2005 at 14:17:24:
It sounds like the murky water is clearing some. It's sounding like the typical hardened wear pad attached to the tip of a rocker like this. You say the pad is 1/8 to 3/16 thick. The valve tips would not all be centered on these pads when assembled. One valve might wear the center of the pad, another valve to the left or right. It would vary depending on the placement of a particular valve tip to a particular rocker at assembly. Maybe that is why you describe them as none being the same. This is normal. The machinist would dress that pad to remove the groove and smooth it up, just to clean up, and to follow the curvature that is there. If the pad is worn thru or so thin there is too little left after dressing it is scrap. Pad hardness could be checked by your machinist I would think he would have a hardness tester. The pad may be case hardened or hardened thru, hard to tell from here.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|