I got lucky with the first crank I ever had to have turned and was directed to the shop that actually does the work, as opposed to dropping it off at a parts house that would send it to them. A crank lathe is a very specialized machine, and the guys that run them will know more than you or I.
My guy looked at the number onthe crank, and went to a book the size of the Manhattan white pages and looked up the base specs for it (so no Farmall-specific experience is necessary). Pulled a mic out of his pocket to run the pins on mine. His assessment was that it had never been turned since manufacture, and he should be able to take it to .010 under, but there were a couple of pins close enough that he wasn't sure he'd be able to polish them at that cut, so he might have to go for .020 under.
In the end, it came back with .010 under on the rods and .020 under on the mains, and stamped as such in the meat of the crank so that the next guy will know what's been done and where he's starting from.
AS far as your crank, trust the machinist. He'll know how much to take it down and is well accustomed to supplying bearings to fit his handiwork. My sense is that it's a bit of a courtesy to buy the bearings from him, rather tha get them elsewhere. And they WILL be the right size.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.