Farmall & IHC Tractors Discussion Board |
More crank bearings
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CNKS on January 11, 2005 at 18:19:12 from (204.249.178.138):
Perhaps the question I asked below should have read "how can I tell when a crank needs to be reground?". My assumption, right or wrong, was that if I used plastigage between the old inserts and the journal, and if the clearance was boderline, as a couple are, that new inserts would decrease the clearance to an acceptable level. I can't see how the clearance could be MORE with new inserts. All this assumes that the crankshaft is within spec as to both roundness and journal diameter, and is not grooved or nicked--I am not sure of this and will probably take the crank to a machinist anyway, that does not mean the machinist has to do anything. Another question is, if the crank is slightly out of round, but still within spec, will it cause excess wear on the new insert, which in theory, is a perfect half circle? Sorry for the questions, but rather than take the engine including the crank to someone and saying, "here fix it", I would like to know what's going on.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|