Farmall & IHC Tractors Discussion Board |
Re: Farmall 300 transmission (picture included)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kelly C on January 03, 2005 at 19:43:27 from (63.171.43.140):
In Reply to: Re: Farmall 300 transmission (picture included) posted by DWV on January 03, 2005 at 18:35:25:
I was kind of thinking on this too. Could you remove the PTO seasonal disconnect insp plate. Push the disconnect forward, Then remove the pto shaft bearing cage bolts. Then some how move the bearing and the shaft forward enough to allow for the removal of the big nut holding the counter shaft in? I suppose if that could be done you could some how get the counter shaft to move rearward to allow for gear removal. That would be no fun!! Better idea if you couldn't actually split the tractor, would be to use 6 x 8 inch grade 8 bolts in place of the bolts that attach the clutch housing to the transmision. Then split the tractor the lenth of the bolts letting them support the units. That would give enough room to remove the pto shaft. Or atleast get enough room to get at the counter shaft. Maybe.....
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|