Farmall & IHC Tractors Discussion Board |
Re: 5088 Questions
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by K.B.-826 on December 19, 2004 at 18:44:16 from (209.163.30.18):
In Reply to: Re: 5088 Questions posted by Leo Crall on December 19, 2004 at 17:20:59:
The transmission is very similar to the Case-IH Magnums, but it is not a full powershift. Basically, you have two levers, one to shift the four ranges- high, medium, low, and reverse, and the other lever shifts the six speeds. 1 and 2 are located right across from each other, and you can powershift between them. If you want to shift to 3 or 4, you need to clutch, but the transmission is syncronized like a Deere, so you can shift on the move. Once in 3 and 4 you can powershift between them. Once again, you need to clutch to get to 5 and 6, but you can powershift between them. You also need to clutch to shift between ranges. When the Magnums came along, Case-IH just replaced the syncros with hydraulic clutch packs, and this transmission became a full powershift.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|