Farmall & IHC Tractors Discussion Board |
Re: Will an IH 464 diesel handle a 2 bottom plow?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on October 05, 2004 at 05:12:09 from (209.226.247.173):
In Reply to: Will an IH 464 diesel handle a 2 bottom plow? posted by Chad Lauer on October 04, 2004 at 19:12:37:
Chad: 464 will handle 2x14 plow in any conditions. Under ideal conditions like sandy loams it would handle 3x14. From the goals you outlined, I would go with the 2 bottom plow. I've owned plows from single bottom to 5 bottom and everything in between. In my years I would give the edge to the 2 bottom plow on quality plowing. That is only a slight edge as all plows will do good work if properly adjusted. Remember tractor wheels should be adjusted aprox 20" to 26" from inside of rear tire to center line of tractor for a 2x14 plow. I have a 2x12 plow and my tractor wheel is 22" from center. With a mounted plow that range of dimesions quite important.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|