Farmall & IHC Tractors Discussion Board |
Farmall M Trojan Loader Questions
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan S (NY) on September 27, 2004 at 14:00:44 from (68.113.167.61):
I have acquired an old Trojan Loader that appears to have been built around a Farmall M from the engine back to the differential housing. The engine has C248 on the block and the casting code puts it in 1953. I am trying to find the fill plug for the rearend gear oil. I have found the two drain plugs and the level plug on the side, but much of the top of the transmission area is covered by the operators platform and I am having trouble locating the fill plug. The machine is also missing the bottom clutch bell housing cover and I would like to get one on before venturing into the brush. Can anyone recommend a place that would have them and how much would I expect to pay for one? Haven’t worked on a Farmall yet so this is fun learning how it works. Somebody has really goofed up the governor/throttle linkage on this thing, I only get about 900 rpm out of it. Been doing a lot of research in the archives and can’t wait to get an I&T to help figure this thing out (the Farmall part that is..) Can’t seem to find hardly any info on old Trojans. Thanks all... Dan
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|