Farmall & IHC Tractors Discussion Board |
H magneto drive timing question????
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John in Ct. on September 15, 2004 at 19:20:07 from (192.233.162.194):
I removed the magneto and magneto drive to replace the magneto drive gasket. I lost the marks that I made for the magneto drive. Through trial and error (from where I thought the magneto drive gear should be) by moving the magneto drive gear one tooth one way or another, I got the magneto to click with # 1 cylinder at TDC at the first mark on the bottom pulley. Am I ok so far? Next, I noticed that the rotor is right before the #1 spark plug wire when it trips, then rotates on by the #1 wire, is this ok? I DID NOT touch the two distributor drive gears. Also, I noticed that the magneto is in a little different place than before(I was able to find the magneto mark I made). The magneto is between the two farthest adjustments, a little more than half way now, the magneto is in a slightly different place than before. Is this a problem? If I move the magneto drive one tooth one way or another and reinstall it, I then have to set the mag at the extreems( Or more) to get it to click at #1 TDC. Thanks!!
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|