Farmall & IHC Tractors Discussion Board |
Yes....unfortunately!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve W (NY) on September 15, 2004 at 13:57:52 from (24.213.210.222):
In Reply to: Farmall b crank seal posted by William Moore on September 15, 2004 at 12:09:22:
That whole front bolster has to be removed as shown in this poor picture. Remove hood and grill, and set them aside. take off the radiator. There are two nuts under that pull it off . My hoses were in need of replacement so I just cut them off. I blocked up the clutch housing, and hung the engine from the rafters just for safety. Unbolt that one bolt that holds the steering shaft to its holder up by the steering wheel. Lay that whole assembly off to the side. If the bolster isn't full of 40 years of crud you'll see 4 bolts that hold it on. Remove them, but first get a way to support that bolster. I used a boom hoist of the bac of my ford tractor, but an engine hoist, or a second come-along from the rafters would probaly work. Slide it all away and you'll have a the cover. Take Care Steve
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|