Farmall & IHC Tractors Discussion Board |
Where's best to add a hydraulic filter to my 364?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Greg on July 30, 2004 at 21:06:48 from (66.137.92.169):
I want to add a spin on hydraulic filter to my IH364 diesel. Although these tractors are very similar to the 444's that came with a hydraulic filter, the 364's did not. I am trying to figure out which line to put it in. I don't want it in the suction line I assume since it could impede oil flow to the pump. I want it in the return line don't I? I think this is right, but I am confused on which line is the return line. The previous owner added 2 remote hydraulic valves. They are "stacked" one on the other. A line runs to one of them directly from the hydraulic pump. The 2 remote valves are connected then a hose runs out of the 2nd remote valve to the fitting just below the seat, between my legs just behind the gearshifter. Is this the line that is the return and would never see enough pressure to blow off a spin on hydraulic filter? Where can I easily by a kit to do this?
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|