Farmall & IHC Tractors Discussion Board |
Re: stack broken at manifold
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by rustyfarmall on July 27, 2004 at 09:01:28 from (216.248.75.152):
In Reply to: stack broken at manifold posted by cc on July 27, 2004 at 08:10:17:
If any part of the stack is still sticking up you can use a hammer and a very blunt chisel to strike the side of the pipe and collapse it inward enough so that you can start working a prying tool of some sort down between the pipe and manifold. The pipe should be quite thin if it is rusted that bad and should peel out fairly easily. Be careful that you do not damage the threads in the manifold. After you get the pipe out you may need to obtain a pipe tap of the proper size to clean out the threads, or you may luck out and be able to screw in a new pipe with no trouble.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|