|
Farmall & IHC Tractors Discussion Board |
Re: H distributor plate marks - possibly for Dave
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave W V on July 08, 2004 at 18:04:02 from (205.188.117.22):
In Reply to: H distributor plate marks - possibly for Dave WV posted by Dave in CT on July 08, 2004 at 09:40:48:
Lot of information I'm referring to is from memory.
Working on these distributors and old literature I have picked up here and there. Also parts books.From memory on gas distributors I have seen shafts marked 22L, 25L, 40L and I think 30L, can't remember shaft marking in some gas start diesels but I do know that a H symbol distributor from the factory had a maxium of 4 degrees cranshaft advance. I find a lot of distributors have had parts changed so they don't match factory original. I just looked at a couple of distributors I have and one was from a N symbol it is marked L22 maxium advance crankshaft 24 to 25 degrees and the hole size is .275. Next one is marked 40L maxium advance crankshaft 40 degrees and hole is slotted .375 long from a A symbol distributor. I either weld holes and file or grind or just grind holes to get what I want. I have one piece of literature that may interest you for fire crater power improvement packages for Farmall H. It says when using Package 374856R91 use distributor shaft with 22 degree marking.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
