Farmall & IHC Tractors Discussion Board |
Re: Woods L503 mower belts?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scotty on July 01, 2004 at 14:42:12 from (205.188.117.22):
In Reply to: Woods L503 mower belts? posted by Chris on July 01, 2004 at 09:12:39:
Low down on belts. What you are looking for is a B 255 v-belt. Top cross section will measure .66 inches and the inside measurement is 255 inches. You can find these at just about any power transmission distributor such as Applied Industrial Trchnologies, Motion Industries, etc. Look in the yellow pages usually under Belts and Belting or Power Transmissin Products. You should save some money this way. B255 belts are stock items from most all major manufacturers. A selling price in the low $30 would allow for a more than fair profit. Almost 50 bucks is HIGH. A secton v-belts measure .500 inches across top, B sections are .660 inches and C sections are .880 inches. The length is measure around the inside. One word of caution, make sure the belts have a cloth finish, belts with raw rubber exposed on the outside edges are too aggresive and can cause things to break.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|