|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: More timing question on a '47 H
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on June 25, 2004 at 11:01:03 from (165.170.128.66):
In Reply to: Re: Re: More timing question on a '47 H posted by Dave in CT on June 25, 2004 at 10:14:40:
Not sure what those other timing marks are (my experience is limited to the “super” series H & M - they have marks only at TDC and 35 deg). My guess is the 4 deg ATDC mark is for magneto impulse setting. (When a mag impulse trip point is set after TDC the engine absolutely cannot kick backward while being hand cranked). The 180 deg mark is useful only when setting the valve lash on #2 and #3 cylinders. My IHC parts manuals call out the distributor centrifugal advance weights/springs as “governor weight” and “governor spring”. Don't know why they did that - it seems confusing to me too… Cannot answer your Blue Ribbon manual question. I’ve got the I&T manual + IHC parts catalogs for both my tractors. So far these have been adequate for my purposes – though the I&T is pretty vague on electrical system maintenance and ignition timing procedures.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
