|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: Farmall 100 (?) Serial Num
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan(VA). on June 24, 2004 at 20:20:37 from (208.59.156.76):
In Reply to: Re: Re: Re: Re: Re: Farmall 100 (?) Serial Number posted by Ramon on June 24, 2004 at 15:40:42:
Ramon,
Thanks for checking on this stuff for us. If you want to see the previous discussion that Hugh and I are referring to, check the link below. I don't have reference to that part number 364898 for the block though. Is it possibly 354898 ? If so I would also like to know the Rev level which is just after that number (might need to look on the other side of the oil filter). I have seen 354898 R1 and 354898 R2 blocks but they do not have the C123 cast into them, so I'm hoping that your's will be either a R3 or R4. The engine serial number on the small machined flat under plug #1 is stamped and not cast like everything else so that might be harder to read depending on how well the engine was cleaned before they repainted it. If you can't make it out I understand, but thanks for checking.
Stan(VA).
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
