Farmall & IHC Tractors Discussion Board |
Re: farmall engine gunk
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmer Bob on June 16, 2004 at 21:12:08 from (64.113.15.209):
In Reply to: farmall engine gunk posted by chris on June 16, 2004 at 19:44:13:
Unless you are elastic man, its going to be quite difficult to clean out that chamber properly without pulling the rocker arm assembly to pull the push rods and dropping the oil pan. Flush it out through the bottom with kerosene after you get the cam followers removed. They will no doubt be pretty stubborn if there is a lot of gunk in their holes. Make sure you wipe off the cam after you clean everything up before reinserting the followers and push rods. I would also recommend you cover the crank up with heavy plastic sheeting to deflect the kero and sludge, you don't need to have a small piece of debris get caught in a rod or main cap and score a bearing.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|