Farmall & IHC Tractors Discussion Board |
Re: Question for Harold H or other CP exp.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Harold H on June 13, 2004 at 18:12:06 from (64.12.117.22):
In Reply to: Question for Harold H or other CP exp. posted by NDS on June 13, 2004 at 15:22:30:
If it wasn't for the pto drive, I would ask; are you sure it was a 20 spindle high high drum? The 414 or 414A look just like the 120 or 120 A except for the 20 vs 14 bars. However the pto drive rules that out. After two rows came out very few one rows were sold in our area. All the high drum one rows I have ever seen drive from a drive box and driveshaft mounted where the tractor belt pulley mounts. Only the fans are belt driven. They also mounted on bullgear equipped tractors (M thru 560). It is oviously one of the newer one row pickers, probably a 502 or 502H. I have never seen one of these and don't know how they are mounted or drive but since they could be mounted on the large frame 06 (706 & 806) tractors which could not mount bull gears, as well as mounting on older (M, 400, 560, etc) tractors, they would fit your description. That would also explain the pto drive as 706, etc, had no place to mount the normal cotton picker drive. If they are like the older one row pickers, there should be a serial number plate with the model number on the left side of the operator platform and also a serial number plate on the header. Sight unseen, that's the best educated guess I can make. As to your rare question, I have never seen one in the Delta and doubt that too many were built. Hope this information helps. Harold H
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|