Farmall & IHC Tractors Discussion Board |
Re: Re: Farmall C Govenor problem
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ken Koch on June 13, 2004 at 11:01:39 from (67.200.32.40):
In Reply to: Re: Farmall C Govenor problem posted by gene b on June 13, 2004 at 03:57:54:
I had the same problem with our Farmall A and B. When I took them apart I found someone had used the wrong parts, parts woren out etc. I had to completely rebuild the governors. Now they work like new. Don't forget to change the pins holding the fly weights in your rebuild. If the holes in the weights are woren to much, you may have to replace the weights also. Most parts, pins, bearings, bushings, gaskets are still available from your Case IH dealer. Make sure you have a good manual before you start also. Rebuilding these governors is a fun little project and is worth the effort. When these governors are in good condition, they are a very sensitive acting governor. Good luck with your rebuild!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|