Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Okay, I got the axle off, how does it
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by KEN PETERSON Pete on May 30, 2004 at 06:11:23 from (12.154.105.126):
In Reply to: Re: Re: Okay, I got the axle off, how does it go b posted by Pat Rivers-Bowerman on May 29, 2004 at 18:34:55:
When you pull the bull gear axle you'll have to take the small square plate off on the inside of the axle, then you'll see a bolt head, loosen it take it and thick washer out. Of course you'll have to remove the wheel and bearing cap on the outside. Then with someone on the outside helping, the axle will come out. If it is tight I use a brass drift on the inside to get it started. As it goes slide a rod "the drift if long enough" through from the inside to hold up the bull gear, then you should have no trouble when you go back with the axle. Of course you should likely change the oil anyway and that still requires dropping the pan, but at least you don't have to hold the parts up in there as you go back. One last thing make sure the tractor is supported securly.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|