Farmall & IHC Tractors Discussion Board |
Re: Slack in Steering Gear - Super A
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Don Swindall on May 28, 2004 at 08:49:09 from (208.35.38.11):
In Reply to: Slack in Steering Gear - Super A posted by Pat Rivers-Bowerman on May 28, 2004 at 07:12:21:
I am in the process of rebuilding 2 tractor steering units. A 100 & 130. I have the 130 ready to go back together. I will let you know if it fixes the problem if you want me to. The pre sized bushings are available. The large one cost me $36.00 the small one was $10.00 and the c-clip was (hold on) $6.00. I bought the seal, the bearings, the woodriff keys at a bearing supply house. They cost me $86.00. The bushing could only be ordered through a Farmall dealer. You cannot totally rebuild it with out pulling the complete front end off, you must get to the bushing and that is the only way. I had to cut mine out with a chesil. The total cost for each tractor ran be about 85.00 each. Which is not bad considering how long the rebuild will last. I was told by the person I got the bushings from, that there is a c-clip on the short shaft and if it is missing it will cause a half round of slack. It is not as bad as it sounds. Good Luck. Don
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|