Farmall & IHC Tractors Discussion Board |
Re: IH 424 Hyd.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JB on May 25, 2004 at 20:37:57 from (64.10.154.235):
In Reply to: IH 424 Hyd. posted by TDK on May 25, 2004 at 00:30:01:
Hi, like someone else said there is only a screen on the suction line from the hydraulic reservior under the seat. If I remember correctly the suction line is the larger line. There is about a 2 inch piece of rubber hose with 2 pipe clamps on it that joins the pipe coming out of the reservior to the pipe going to the pump. Loosen the clamps and slide the rubber hose towards the front of the trator, then rotate the pipe coming from the reservior so that it will pass the other pipe and pull it out of the reservior. There should be a screen on the end of the pipe. We would place the tractor on an incline so the front end was much higher than the rear to prevent the hydraulic oil from all running out. Put some oil on the O ring before reinserting in the reservior. Be sure to apply parking brake and block wheels if you put tractor on incline to clean filter. Be careful JB
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|