Farmall & IHC Tractors Discussion Board |
Re: Re: Re: super c rod and main bearings
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ed on May 12, 2004 at 20:38:02 from (216.93.26.156):
In Reply to: Re: Re: super c rod and main bearings posted by Jim on May 12, 2004 at 17:58:22:
ITS IN THE OIL PUMP.....AFTER YOU TAKE THE OIL PUMP OFF, LOOK VERY CLOSELY AT THE BOTTOM PLATE, SEE IF IT LOOKS LIKE IT IS LEAKING (ACTUALLY SUCKING).....THEN TAKE THE PLATE OFF TO SEE IF A PORTION OF THE GASKET IS MISSING....LAY THE PLATE ON A PIECE OF WINDOW GLASS, SEE IF A .002 FEELER GAUGE WILL SLIDE UNDER IT AS YOU ARE PRESSING DOWN ON IT...MY PUMP WAS OBVIOUSLY WARPED (COULD SEE IT WITH THE NAKED EYE)....THE PUMP PLATE USUALLY WARPS WHERE THE PRESSURE RELIEF SPRING PUSHES DOWN ON THE PLATE (THE PLATE ONLY HAS 4 BOLTS, I THINK IT WOULD HAVE BEEN NICE IF IH ADDED ONE MORE BOLT).....2 BOLTS ON THE OUTSIDE OF THE BLOCK HOLD THE PUMP ON.....YOU WILL NEED A REPAIR MANUAL, FIND ONE SOMEWHERE....KEEP IT NEXT TO YOUR TOILET, STUDY IT REAL GOOD, THEN DIVE IN !! (to the tractor not the toilet)....GOOD LUCK, HOLLER IF YOU GET STUCK, ED
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|