Farmall & IHC Tractors Discussion Board |
Re: steps to remove Radiator on FARMALL M
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmer Bob on April 18, 2004 at 21:55:16 from (64.113.13.56):
In Reply to: steps to remove Radiator on FARMALL M posted by Brad on April 18, 2004 at 20:26:10:
Yes the steering shaft has to be removed. Unscrew the large plug at the top of the upper bolster. Loosen the clamp at the u-joint by the gauges and screw the shaft out through the front of the upper bolster. Disconnect the upper radiator support bar and upper radiator hose. Loosen the clamps on the bottom radiator hose. Take the fan shroud off. Remove the cotter keys and castellated nuts from the two studs in the bottom of the radiator that go through the base of the bolster. Pull the radiator up and away from the fan blade. Can't recommend strongly enough that you invest in a service manual!!! A Parts manual is just as valuable as well as an Operators Manual.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|