Farmall & IHC Tractors Discussion Board |
Lesson on TA in 350U Wheatland Gas please
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Sean in Calgary on April 12, 2004 at 08:22:45 from (66.244.207.150):
I haven't been on here much lately but now that I am back I am seeing a lot of questions about TA's again. I have never tinkered with mine as I try to live by the rule 'If it ain't broke, don't fix it' but at the same time if I am setting myself up for damage later by not doing some preventative maintenance, then I would rather do that then have to tear my little red work-horse apart. Here's the deal. Most of the time I run my tractor (a 1957 350 Wheatland Special Gas) with the TA lever pulled towards me - that is the low speed setting. When I have it thrown away in the high-speed setting I cannot shift gears or get the foot-clutch to totally disengage. Even with the clutch on the floor plate I can feel the tractor surge a little bit and there is no way I can get it to come out of gear. Am I wearing anything with it setup the way it is? My thought was that it was inconvient and not working quite the way it was designed but at the same time this setup would ensure that I was not having clutches slipping because they could not totally engage. Any thoughts? I do have the original owners manual, so if I need to go back over it in regards to adjusting clutches and TA then just say so. If there is a better way to skin this cat that you have learned from experience, then I am willing to take suggestions. Thanks in advance, Sean
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|