Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Hey, I've got a Farmall C, cou
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan(VA). on March 31, 2004 at 11:48:38 from (69.19.0.1):
In Reply to: Re: Re: Re: Re: Hey, I've got a Farmall C, couple posted by Bill M on March 31, 2004 at 09:52:38:
Make sure the comparison is equal. The cheaper kit may be just pistons/sleeves/gaskets/bearings, while the other kit may also include the valve train set (valves/guides/springs/keepers/seals). Not saying it's a good deal, just compare apples to apples. General Notes: The comment on reconditioning the rods is good, so make sure you get the pin bushings with your OH set. Pull a sleeve and measure the bottom OD at the O-ring seal to make sure which sleeve set you need (3 5/16" for the original C motor, possible 3 7/16" on a replacement block from a Super C). Mill the bottom plate on the oil pump flat. Make sure you keep all the main and rod bearing caps in the right place, they don't interchange. Stan(VA).
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|