Farmall & IHC Tractors Discussion Board |
Re: 560 hydraulic problem
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Joe Evans on March 28, 2004 at 04:54:36 from (209.41.235.88):
In Reply to: 560 hydraulic problem posted by joe on March 27, 2004 at 18:08:53:
Man, oh man, Joe. I have just gone thru the EXACT same thing with a 460. I still don't have it completely resolved, but I'm close. Well, number one, you've got to fix the Tel-A-Depth differential gears. Number two, bet you ten bucks to a donut the orifice plug and screen is plugged. Just behind the sheetmetal where the brake set pull rod attaches, are the Hydra-Touch spool valves and the Tel-A-Depth spool valve. Also in this area and mounted low close to the transmission is the pressure relief/pressure regulator control. According to the I+T manual, location of all this stuff is self evident. Hardee har har. The orifice plug can be accessed by removing the regulator block cap and its 4 cap screws. The cap faces rearward toward the gear shift. Unscrew only two of the cap screws and remove them. Then insert longer cap screws in these holes, then back out the two remaining original cap screws. This keeps the pressure relief spring from launching into the back 40. The orifice plug is noted by its screwdriver slot. It will be staring right at you. Remove it and check it. If this is plugged, the regulator valve can't get a signal to dump pressure during over-pressure conditions which is what you describe. Check the screen and the orifice plug hole. My over-pressure squealing conditions are resolved. Now I can't get the hitch to settle down. Some coffee, reading glasses, and my brother's brains will get this fixed. Then I'm going to plow.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|