Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: 484 Clutch
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JB on March 05, 2004 at 14:44:01 from (24.157.143.220):
In Reply to: Re: Re: Re: 484 Clutch posted by Mac on March 05, 2004 at 09:49:24:
Hi, Clanger, that is the spring. I helped my brother replace clutch, pressure plate, throwout and pilot bearings in a 454, 495 and 684 in the last three years. The 495 was new in 91 or 92 and all the tractors had the same mechanical release bearing setup. We also replaced the clutch in the 454 and 495 with the HD six paddle clutch that is for the 684. When I picked up the clutch parts at the IH parts counter, John (has 20 + years of IH parts experience and he is the only one that I will deal with) said only the 695s and beyond would have the self adjusting hydraulic type clutch. I have seen these self adjusting hydraulic throwout bearings on 7000 Fords and the replacement cost is $200 or more. The IH throwout bearing was about $30.00. If Dale had to pay in the range of $200 for the throwout bearing for his 484 then it possibly is a hydraulic self adjusting one. JB
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|