Farmall & IHC Tractors Discussion Board |
Re: removing the belly pump on a super M
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stuart on March 01, 2004 at 08:19:19 from (137.104.162.48):
In Reply to: removing the belly pump on a super M posted by John (AZ) on March 01, 2004 at 07:25:00:
Will the engine turn over with the trans in neutral? Where did the last owner say he heard the pop comming from? There could be something between two gears in your transmission. Even then the engine should move with the trans in neutral unless your clutch will not realease. I would look at the clutch first thing after you get the pump out of the way. Then try to turn the engine over with the clutch pushed in. Another thing is that something could have let loose under the timing cover and be jammed in your timing gears. If your Super M has the hydraulic pump mounted just ahead of the distributor type letting the clutch out could of torqued the engine enough to mess something up in the timing gears. Post back if you have any luck. Hope this helps
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|