|
Farmall & IHC Tractors Discussion Board |
Live and Learn!! Kinda long story.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob in SE Nebraska on February 29, 2004 at 08:07:13 from (162.40.71.72):
I always enjoy learning something new and the H that I am restoring gave me a pretty good lesson today. This tractor had a badly frozen block that I learned of as I took it apart. I was lucky enough to find another block at a salvage yard and the price was very reasonable so I felt it was worth the money and effort to restore the tractor. This process has taken about a year now so it isn't something that I have done in a short time frame. I had the tractor all back together last spring and I mounted a cultivator to it and used it to take care of my large sweet corn patch. The tractor started to act up by either only running at idle or running full throttle. I took the cover off of the govenor and could see that it was not getting any oil to lubricate it. I just quit using it and finally last week I took the front end of the tractor off to find out where the oil passage had been blocked. After much thought and looking at the old block that came out of the tractor I localized where the blockage had to be. I pulled the cam out and sure enough the front cam bearing had not been installed with the oil holes in the proper place. The bearings that came with the block seemed ok so I didn't replace them. My lesson learned is to check the bearing alignment with the oil holes. I would have never thought a block that came from a salvage tractor would have that bearing placed in it wrong. Almost back together now and I am looking forward to using the tractor and painting it later on this summer. It was a fair amount of extra work but I guess it was just another one of those lessons! Bob
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
