Farmall & IHC Tractors Discussion Board |
Re: Re: Tighten up steering on Super A
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on February 28, 2004 at 18:39:05 from (209.226.106.106):
In Reply to: Re: Tighten up steering on Super A posted by Dave, Sherburne, NY on February 28, 2004 at 17:17:29:
Dave: Actually the most sucessful one I've done is the one we welded a key in the keyway of shaft and pressed the cog on the shaft. I've always been a bit reluctant to pass that on as I felt it was more good luck than skill that it came out so well. The keyway on this unit was damaged so badly, it was my opinion shaft was toast anyhow, so what did I have to loose. On the matter of tapered shaft, my Super A serial number 336977 has the tapered shaft. I can't enlighten you very much on that as I have never been involved with a steering box older than that. I was aware of the square shaft but not when change occured. Tyrods, etc changed around 51 so maybe other front end items at that time, just a guess.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|