Farmall & IHC Tractors Discussion Board |
Re: Tighten up steering on Super A
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave, Sherburne, NY on February 28, 2004 at 17:17:29 from (216.238.58.129):
In Reply to: Tighten up steering on Super A posted by J Risher on February 28, 2004 at 14:20:44:
Did you check the steering arm where it fastens to the vertical shaft through the steering gear box. The end of the shaft is probrobly square with a square hole in the steering arm. I'll bet it is very sloppy. Poor design, changed to a tapered end shaft with key which could be tightened . That said, I put shims on my square shaft and it was tighter. That was on the A. On the super A, I found an old knowledgeable parts man who knew that IH at one time offered a repair kit which changed the square end shaft to a tapered one. The kit is no longer available, but the individual parts are . Hugh can probrobly tell you which tractor started using the tapered end shaft 100, 140 or whatever. The shaft and new arm takes care of outside the gearbox slop, but the inside sector gear will still need work. I had a new keyway cut in the shaft and 180 degrees from the old keyway. But I'll bet Hugh's method works as well and is cheaper.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|