Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: Re: Re: Re: Re: Gardening with a tractor


[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by riverbend on February 24, 2004 at 07:49:09 from (208.160.33.220):

In Reply to: Re: Re: Re: Re: Gardening with a tractor posted by mark on February 24, 2004 at 06:07:19:

Hugh MacKay is spot on with most of his advice.

A few things that I have found are:

Longer rows work better with tractors and cultivators. If you don't have wide headlands to turn around on, the first few feet of your crop will suffer as you get straightened out.

Setting up cultivators will take some trial and error. They usually work by moving soil rather than cutting off the weeds. Start with the shovels set a foot apart until you get the hang of adjusting your speed and depth to get the results that you want. You will need to be handy with the hoe for a while. Your local IH dealer will have new sweeps, but no real variety.

Unless you are very good with a push planter, the cultivators will only be good for rows that you planted with the mounted planters. Sorry can't help you with their set up, I'm using Planet Jrs and JD 70s.

If you are going to plant a lot of corn and squash, you might want to consider larger garden areas. Four 35 X 300 beds cover about an acre.

With cover crops try to alternate between broadleafs and and grasses. They compete with different weeds. Buckwheat is used more up here, but should work for you in the spring and fall, if not all season. Look at the ATTRA or the Univ of NC website for some ideas.

I grow vegetables in a four year rotation, but went away from a bare fallow because it was burning up my organic matter. Now I use soybeans and sorghum planted in rows and cultivated. Something like that would also give you a place to practice your cultivator skills without wiping out your green beans.

Getting the black plastic laid tight takes some careful set up even with a purchased plastic layer. You might want to consider putting drip tape in at the same time. You can buy a thing called a "water wheel" that will punch holes in the plastic and put some water in the hole. You would have to make your own frame. There are complete water wheel transplanters, but that might be a bit much for a garden.

Beds or rows work better for different crops depending mostly on how you are going to cultivate and harvest.




Follow Ups:




Post A Followup

:
:

: Re: Re: Re: Re: Re: Re: Gardening with a tractor

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy