Farmall & IHC Tractors Discussion Board |
Re: Re: fast hitch
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on February 18, 2004 at 19:09:48 from (64.228.11.1):
In Reply to: Re: fast hitch posted by scotc on February 18, 2004 at 17:36:37:
Scot: You do have a good suggestion as the frames of those two plows are the same. The only part different is the pull beam and it is interchangable, so he could make up a single point fast hitch pull beam for the plow without destroying the 2 point pull beam. As far as picking up plow or disk I wouldn't worry about breaking anything as Super A will not lift that much. I have a single point 6' S tine cultivator I fabricated, 18 teeth on three tool bars. I did intend building or buying a crumbler. I now have 6.5' heavy angle iron with chains on each end to pull it for leveling and crumbling. When I leave field I throw the heavy angle on top of the cultivator. I have to place this quite close to hitch point or these little tractors will not lift the cultivator. I also have a 60 gallon sprayer, with 20' boom. I fabricated the mounting so weight is as close to tractor as possible. If that sprayer is full, I have to push on hydraulic lever then lift by hand on sprayer. These tractors will lift it with my hand help. However I do have concerns re the strength of hitch linkage so I use two chains to carry weight while spraying. Super C and 200 using a remote cylinder for the hitch will lift substancially more than the Super A, 100, 130 or 140 with the touch control rockshaft. These little tractors fall down on lift quite quickly when the weight is back 3' or 4' from hitch point.
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|