Farmall & IHC Tractors Discussion Board |
Re: Re: Re: 113 or 123 cid engine?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on February 12, 2004 at 20:22:27 from (209.226.106.159):
In Reply to: Re: Re: 113 or 123 cid engine? posted by Dave_Id on February 12, 2004 at 19:32:22:
Dave: Good point, I may be wrong on that, I just looked at IT manual for C-123 and C-135 engines. They do use the same block for 3-1/8 and 3-1/4 respectively. There may be the answer. I was in another discussion on this forum and I believe early C-113 can be bored for 3-1/8 sleeves and pistons but not 3-1/4. I am certain they talked boring one of them and there would be no reason to bore the newer C-123 - C-135 block. I also happened to check the part number on my Super A today C-123 block part number 354898R1. I didn't check the complete number on my 130 or 140, but at a glance could see they were each completely different from Super A. I have also seen two other completely different part numbers from Super A's today, both those had mag ign. None of those 5 part numbers were the same as yours. That doesn't surprise me. I think there are other numbers as well.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|