Farmall & IHC Tractors Discussion Board |
Re: grain binder bull wheel
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on February 05, 2004 at 00:06:25 from (216.208.58.158):
In Reply to: grain binder bull wheel posted by farmerjohn on February 04, 2004 at 20:03:26:
John: I am not sure I'm right but here are my thoughts. There was an old Deering binder still in use on our home farm into thr 50s. It probably was as old as the one you have. Shortly after WW#2 the bull wheel had to be replaced on our binder. I was quite young back then but do remember the spokes on the steel wheel broke off at the hub. Why it wasn't repaired, I can't tell you. My dad and grandad were very frugal men, so it must have been less expensive to replace the wheel. Maybe it had been repaired once by that time. I do know our binder wheel was replaced by a new steel wheel. I have reason to believe other binder wheels were replaced in that era as well. When I was a kid it was common to see binder bull wheels lying around farms and not on binder. My thoughts are that rubber tired bull wheels probably were not available until after the war.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|