Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Hydraulic strength?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark on February 02, 2004 at 10:24:50 from (199.46.199.230):
In Reply to: Re: Re: Re: Hydraulic strength? posted by Jim on January 31, 2004 at 10:16:52:
Get a high pressue gauge (Northern Tool has a 0-5000# for $10). Put it in your high pressure line and measure the pressure with the tractor at PTO speed. Put the hydraulics back like they were. Measure the internal diameter of your cylinder (piston width across the top) and divide by 2. Take this number x the same number x 3.14. Multiply this by the pressure you measured and you have your lift capacity at the cylinder. Any lift arm length will either add to this or subtract depending on whether or not you have distance between the cylinder and what you want to lift. So for a 1200 lb measurement of pressure, and a 3" cylinder we have 3"/2 = 1.5" x 1.5" x 3.14 x 1200 psig = 8482 lbs lifting capacity according to my calculator. If the lift arm pivots at the tractor and the cylinder is 1 ft from the tractor and the length of the arm (at the point where you are lifting) is 3' from the tractor then you have a second class (as I recall) lever gain of 3' - 1 ' = 2 ft so lbs x ft = 8482 x 2 (feet x pounds....ft-lbs)or 16,964 lbs lifting capability. Now with that said, the practical side of all this is hydraulic leaks, piston blow-by and ability of your tractor to support that kind of load. Probably a couple of thousand pounds is more practical. Awesome isn't it, what hydraulics do for us every day in every walk of life. Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|