Farmall & IHC Tractors Discussion Board |
Re: Broken grease zerks
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jeff on January 22, 2004 at 15:21:57 from (216.107.17.158):
In Reply to: Broken grease zerks posted by Randy on January 22, 2004 at 10:37:45:
Slow and easy does it. Cordless drill on slow speed AND slowly. You will find that most of the time these don't go all of the way to the bottom of the hole. LONG time ago I did my dad's 300 and it might be a 1/8 drill. NAPA had them and they are real little. Use a brass hammer to reinstall them. Clean out the hole with an air hose but wear eye protection or close your eyes and turn away!!!! If the grease is REALLY old and hard you can heat the casting a LITTLE with a tourch with pressure on the fitting at the same time with a grease gun. That will make the grease flow most of the time. Fun-Fun Jeff
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|