Farmall & IHC Tractors Discussion Board |
What engine have I got?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ed on January 18, 2004 at 20:49:33 from (64.12.97.12):
Brought home a B from my Aunts place this fall. The tractor was in a half fallen down shed and hasn't run in who kows how long. The engine was stuck but it came apart fairly easy. I cleaned up the sleeves and they didn't look to bad until I measured the bores and found out how worn they were. OK, so now it needs sleeves and pistons. No problem, I have a set on the shelf for a F-12/A/B so I get one of the new sleeves and check it against the old ones and the bottom outside diameter is 1/8 bigger on the old ones (where the seal sits).The bore of the old ones is 3". Then I start stripping down the rest of the block and notice the plate blocking the hole under the distibutor mount. Looks like a mounting for a hydraulic pump.It also has a dipstick. I need to know what this engine is so I can order the right sleeves, gaskets, etc. The block casting number is 356818 R2, serial # IMAM 18781. I have the parts book for the A and B but that number's not in there. Could it be a Super A or C block? Thanks in advance for any help you can give. Ed
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|