Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: end play
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by To Acesrebuilder on January 16, 2004 at 19:59:48 from (65.120.161.62):
In Reply to: Re: Re: Re: end play posted by rebuilder on January 16, 2004 at 17:10:30:
I got the bull pinion out! Boy, that saved me a lot of extra work. I couldn't seem to get my axle to slide by taking off the axle cap though. I went ahaid and removed the entire axle housing. The older I get, the more hesitant I am to beat and really pry on things, which is probably a good thing. The old seal on my bake shaft was alomost 3/4 of an inch thick. The new IH seal is now just a tin seal with a rubber lip. What do you think about putting two of these seals in and packing grease between them? I remember rebuilding a Bushhog this way when the old seal substituted to two identical ones, which were to be installed together. Rebuilder, that's a good idea, I will take the other side apart. Besides, this is great fun! Thanks again, SGT K
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|