Farmall & IHC Tractors Discussion Board |
Re: Re: Re: end play
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by rebuilder on January 16, 2004 at 17:10:30 from (66.228.102.151):
In Reply to: Re: Re: end play posted by SGT K on January 16, 2004 at 13:20:00:
Sarge; We have used this procedure several times to fix inner axel bearings as well. It saves taking deck plates off. As you suspected, the axle cap IS the seal retainer held with four bolts. This also is a retainer for the outer axle bearing. Getting it apart is not to bad, take bolt out of bull gear and slide axle out. As aces said much care is needed to protect the bull pinion cage. There is not a lot of room but it is doable. I would recommend a buddy to help you put it back together though. It can be a son-of-gun to get the bull gear lined up with the splines on the axle, while making sure the bull gear is engaged fully into the bull pinion. Our axle had a bur or something on the spline and boy did that drive us nuts for a while. We got it on though. Just use a lot of patience! Since you are working on an H the hardware will not be near as heavy as an M or Super M. Also; while you are in the rear I would take off the other bull gear to make sure the Inner axle bearing is not going out. If you have any more problems/questions get back to us.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|