Farmall & IHC Tractors Discussion Board |
Re: Re: Re: To SHV Owner or SHV Expert
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on January 07, 2004 at 14:21:28 from (64.228.11.1):
In Reply to: Re: Re: To SHV Owner or SHV Expert posted by Bud on January 06, 2004 at 20:16:16:
Bud: I went for that visit today, and came up with the same figures as riverbend, mainly due to the fact this manual was for H and HV also. However looking at some close up shots of the axle carrier and final drive, the whole unit is completely different from the regular tractor. In other words it is not a H axle carrier with a final drive added. The axle carrier portion is definately for HV only and couldn't say for sure but think carrier and final drive are one piece. Having said that I would expect the same castings were used on SHV as on HV, as it applies to dimensions. I expect the only difference you will find between HV and SHV as it applies to wheel tread, is the actual way rim fastens to wheel. So if minamum tread on HV with wheels dished in is 60" quite likely SHV may go to 56" 0r 58". My opinion you will be able to get SHV as narrow or even less than HV. I hope this works for you, best I can do.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|