Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Charging and Ampmeter on Cub L
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on January 06, 2004 at 07:38:58 from (165.170.128.65):
In Reply to: Re: Re: Re: Re: Charging and Ampmeter on Cub Loboy posted by Red Raider on January 06, 2004 at 06:06:44:
Another test you can try: Disconnect the wire from the generator ARM terminal and temporarily ground the FLD terminal (run a wire from the FLD terminal to a GOOD ground). Now run the engine at speed and measure the voltage at the ARM terminal. If the generator is good you will see 15 – 20+ volts between ARM and ground. Note: A 6 volt truck generator can be installed on your Cub, but you must have the matching truck voltage regulator for it to work correctly. Also you may have to mess around changing pulleys to get the generator to spin at the proper RPM.
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|