Farmall & IHC Tractors Discussion Board |
grinding valve seats on a cub?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by shannon on December 24, 2003 at 12:24:14 from (199.224.83.77):
have bad valve seats on a cub. and i was just wondering how to refurbish them. i was going to get some valve grinding compound and try to lap them a little but i dont know if tahts going to work as i dont know if ill be able to get a good grip on the valves to do taht. and do you have to take out the cam to get the valves out on a cub? right now i just have the head off and trying to figure out the best way to get the job done without taking it all apart. this is the first time working on a cub and the i+t shop manual was very helpful, as according to them the only thing you need to know about valves and seats on a cub is that there 45 deg 3/64 wide and they must be in the block permanetly cause theres no removal instructions or pictures. thanks
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|