Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Removing bearing from axle with re
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Larry Kastens on December 22, 2003 at 07:25:38 from (216.39.190.39):
In Reply to: Re: Re: Re: Removing bearing from axle with retain posted by gene b on December 22, 2003 at 03:06:32:
The inner bearing came out easily. I am referring to the outer bearing which is next to the retainer and the wheel hub. The retainer is within a quarter of an inch of the hub and one must be able to get some kind of remover to remove the bearing next to it. Does a person have to cut off the bearing so he can slide the retainer off? This particular axle shaft has the hub cast on the outer end so the seal can't be removed from that end. I suppose I could cut the bearing off and then try to find a sealed bearing that would replace it, since the retainer is now cracked. What are your thoughts?
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|