Farmall & IHC Tractors Discussion Board |
I been havin' FUN!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mitchissippi on December 21, 2003 at 20:21:38 from (64.89.166.103):
Some of you may remember me asking a whole bunch of questions about my 1066 transmission and it's problems. I ended up buying another tractor with a bad engine, and putting the two together to make one good tractor. I had all this done in time to use the tractor this fall, to do all my yearly clipping and grading. All Hi range gears and first / low makes some noise, and I still have some adjusting to do on the shifter, but everything seems to be working fine. Well, this weekend was dry enough to move dirt, so I hitched up to my 5 yard pan and headed out to fill in and old ditch run in one of our cotton fields. I was borrowing dirt off an old gray, clay ridge. I've never had so much fun driving a tractor in all my life! I don't have any weights on the front-end and the area where I was loading was hard. I like to cut in 2nd gear low, in hard ground and that ol' 10 would raise the front wheels about a foot and when dirt started spilling over the sides of the pan, I'd start shutting the gate and the front end would ease back down. THAT, my friends, is FUN! Conditions were just right. That particular tractor, set up the way it is, had found ground just right to load it up, and it was pulling all it possibly could and never faultered. It don't match all up like that often. Just thought I'd share this and thank everyone on this board for the help you all have been. This 1066 is my first Farmall. Hope everyone has a good and safe holiday. Mitch
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|