|
Farmall & IHC Tractors Discussion Board |
4000+ hrs on gas engine, how much longer will it h
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gramps544 on November 16, 2003 at 16:46:15 from (65.176.241.198):
I have a I-544 with 4000+ hrs. It is a gas 4 cyclider model. It does not have replaceable sleaves so it is not easaly rebuildable. I know it could be rebuild, but the block would have to be drilled out and oversized piston put in (if available). Anyways, as this is not simple matter of replacing sleaves and standard pistons, I feel these engines typically are not rebuilt. When they go, mostly the tractors are parted out. My question is, under normal useage, what is the life expectancy of these engines? Correct me if I am totally wrong on my formula, but I would say for an automoble engin an adverage speed of 40 miles an hr is a good estimate. Taking 40 miles/hr * 4000 hrs = 160000. For a gas automoble engin, this is getting up there. Is my engin approching end of life?
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
