Farmall & IHC Tractors Discussion Board |
touch control and sickle mower
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by FC on November 04, 2003 at 05:35:15 from (66.84.205.26):
This past weekend I decided to try to get dads old #31 sickle mower going to do some cutting that needs done before winter. Besides I may use it next year to cut hay. It had not seen duty for approx 15 years or so. Needless to say the wooden pitman only lasted about 20 minutes. To make a long story short I lost the spring which goes into the end of the pitman between the wooden part and the metal end somewhere in the field. Does anyone have the part # or know if these are available any longer? I believe this uses the same basic parts as the 27 mowers, as the pitman I bought showed it would fit them as well. 2nd question: My touch control is leaking pretty heavily where one of the control rods enters the unit. It appears there is a boot which is pulled away or ?? as I can see the shiny rod where it is leaking. Is there any way to repair short of removing the unit and rebuilding? Thanks in advance.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|