Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: M piston size and turbo
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Troy - MI on October 25, 2003 at 17:31:39 from (216.65.171.173):
In Reply to: Re: Re: Re: M piston size and turbo posted by Dr.EVIL on October 25, 2003 at 05:09:04:
Think about it. The position of the pistons match the firing order. Each piston in the order are 180 degrees from each other. 1 is 180 from 3 is 180 from 4 is 180 from 2. Changing the camshaft order to 1-4-2-3 would mean that piston 4 would be 180 degrees 'out of phase' WRT the cam. Same story for piston 2. The distributor timing could be changed to match cam timing by switching plug wire locations. But pistons 4 and 2 would be at the bottom of their cylinders when their plugs fire. If only the camshaft/plug wire timing were changed, you could get away with getting the engine to rotate in the opposite direction. This is how twin/four engine piston-powered aircraft engines are designed. My first passion is building '60s Pontiac GTOs....I've tried so pretty strange stuff to get more HP. But forging and milling a new crankshaft is beyond my abilities. Troy - P.E.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|