Farmall & IHC Tractors Discussion Board |
Re: Re: Re: M piston size and turbo
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dr.EVIL on October 23, 2003 at 07:35:45 from (12.4.181.2):
In Reply to: Re: Re: M piston size and turbo posted by sod on October 22, 2003 at 22:37:22:
The intake ports are siamesed, meaning they split into two ports inside the head. This is O-K for a naturally asperated engine since the first cylinder starts the air/gas mixture moving into the first cylinder and when the intake valve closes the mixture is already moving and just diverts towards the other cylinder with the open intake valve. Under boost You exaggerate this situation and would have one cylinder getting more mixture than the other, making more power and making tuning a bear! It "MAY WORK" with the OEM firing order, but it would probably work better with it changed. In order to make the turbo fit I'm assuming your throwing the entire intake/exhaust manifold out and fabricating from scratch. I saw a 1939 to 1942 gasoline powered FARMALL M at a Super Stock tractor pull 30 yrs ago in Davenport, IA that was turbo-charged but I never saw the left side of the engine to see how He had it plumbed. He was still running the IHC Magneto. He also had PLENTY of power for the class He was pulling in! I also have a small picture with caption from a farm magazine from 25+ yrs ago about a Farmall H that was turbocharged. Gas engines really don't lend themselves to turbocharging. The pressurized fuel/air charge burns WAY too hot. And most people try to run way too much static compression. A good turbocharged gas engine needs to have 6 or 7 to 1 compression, REAL good gas, Best ignition possible, and then should be able to make 2, maybe 2-1/2 HP per cid. The trick is to run low compression with LOTS of boost. Even diesel engines run this way now.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|